Adjust The Length Of The Driveshaft - Nogueira VMN 4.0 Manual De Instrucciones

Procedure for setting the header to leveling:
1- Chock the wheels.
2- Use the hydraulic jack and a wooden wedge to hold the VMN
4.0.
3- Loosen nuts (3) and remove the screws (4).
4- Position the header combining drilling up or down as needed,
according the height of the tractor.
5- Place the screws (4) and nuts (3) and torque (see table
torques) from the end of the manual.
Attention:
The header weighs 120 Kg, so it will be necessary
to use a winch or more persons to hold the header
and avoid accidents.

Adjust the Length of the Driveshaft

Removing the fairing protecting the PTO:
A) Disengage PTO mixer.
B) Follow the instructions in item Maintenance of the driveshaft,
to remove the protective fairing.
For the following, the tractor should be turned
off and the key out of ignition.
Checking and adjusting the length of the PTO:
A) Engage the tractor mixer.
B) Always operate the tractor so that the rear tires to a close as
possible to the header.
VMN 4.0
3
2
1
1
Tractor
3 cm
2
2
4
5
3 cm
Mixer
15