Optika Italy B-510 Serie Manual De Instrucciones página 11

4. Connect the illuminator cable ⑥ to the connector
⑦ placed on the back side of the frame. (Fig. 5)
5. Insert the optical head above the epi-illuminator
and tighten the locking screw ⑧ with the provided
Allen wrench. (Fig. 6)
• Hold the head with one hand during the
locking in order to avoid that the head falls.
(Only B-510MET-R)
• Condenser is pre-installed in the factory. To
remove the condenser use an Allen wrench
1,5mm diam and operate on the locking screw
placed on the right side of the condenser holder.
6. Insert both eyepieces into the tubes of the optical
head. (Fig. 7)
7. Screw each objective into the thread of
the nosepiece,
magnification. (Fig. 8)
clockwise with increasing
Page 11
⑦
⑥
⑧
Fig. 5
Fig. 6
Fig. 7
Fig. 8