Unpacking The Refrigerator; Choosing The Proper Location - Signature UPFXC2466 Serie Manual Del Propietário

10 INSTALLATION

Unpacking the Refrigerator

WARNING
• Use two or more people to move and
install the refrigerator. Failure to do so
can result in back or other injury.
• Your refrigerator is heavy. When moving
the refrigerator for cleaning or service,
be sure to protect the floor. Always pull
the refrigerator straight out when moving
it. Do not wiggle or walk the refrigerator
when trying to move it, as floor damage
could occur.
• Keep flammable materials and vapors,
such as gasoline, away from the
refrigerator. Failure to do so can result in
fire, explosion, or death.

Choosing the Proper Location

Water Water supply must be easily connected for the automatic icemaker.
Water pressure 20–120 psi on models without water filter. 40–120 psi on models with
water filter.
Electricity Use an individual, grounded outlet:115 Volts, 60 Hz, AC, 15 Amps
minimum.
Floor Floor must be level and solidly constructed. Adjust the leveling legs to
compensate for any unevenness in the floor. Do not install on carpeting,
soft tile, a platform, or a weakly supported structure.
Ambient Temperature must be between 55°F (13°C) and 110°F (43°C). If the
temperature
ambient temperature is too low or high, performance may be affected.
Clearances
Allow at least 24 in. (61 cm) in front to open the doors. Allow at least
2 in. (5.08 cm) between the back of the refrigerator and the wall. If the
refrigerator is too close to adjacent items, freezing capability may decrease
and electricity consumption may increase.
• Remove tape and any temporary labels from
your refrigerator before using.
Do not remove any warning labels, the model
and serial number label, or the Tech Sheet that
is located under the front of the refrigerator.
• To remove any remaining tape or glue, rub
the area briskly with your thumb.
Tape or glue residue can also be easily removed
by rubbing a small amount of liquid dish soap
over the adhesive with your fingers. Wipe with
warm water and dry.
• Do not use sharp instruments, rubbing
alcohol, flammable fluids, or abrasive
cleaners to remove tape or glue.
These products can damage the surface of your
refrigerator.
• Reinstall or adjust shelves as needed.
Refrigerator shelves are installed in the shipping
position. Reinstall shelves according to your
individual storage needs.
WARNING: Do not overload house wiring and cause a fire hazard
by plugging in multiple appliances in the same outlet with the
refrigerator. To reduce the risk of electric shock, do not install the
refrigerator in a wet or damp area.