Signature UPFXC2466 Serie Manual Del Propietário página 50

50 MAINTENANCE
Application Guidelines/Water Supply Parameters
Service Flow 0.5 gpm (1.9 lpm)
Water Supply
Water Pressure 20 -120 psi (138 - 827 kPa)
Water Temperature 33°F - 100°F (0.6°C - 38°C)
It is essential that the manufacturer's
recommended installation, maintenance and
filter replacement requirements be carried out
for the product to perform as advertised.
NOTE
• While the testing was performed
under standard laboratory conditions,
actual performance may vary.
Replacement Cartridge: ADQ36006101
For estimated costs of replacement elements
please call USA 1-855-790-6655
(24 hours per day/7 days per week) or visit our
website at www.signaturekitchensuite.com
3M is a trademark of 3M Company.
NSF is a trademark of NSF International.
© 2009 3M Company. All rights reserved.
WARNING
To reduce the risk associated with choking:
• Do not allow children under 3 years of age
to have access to small parts during the
installation of this product.
To reduce the risk associated with the
ingestion of contaminants:
• Do not use with water that is
microbiologically unsafe or of unknown
quality without adequate disinfection before
or after the system. Systems certified for
cyst reduction may be used on disinfected
water that may contain filterable cysts. EPA
Establishment # 070595-MEX-001
Potable Water
Manufactured for Signature Kitchen Suite by
CUNO Incorporated 400 Research Parkway
Meriden, CT 06450 U.S.A Worldwide: 203-237-
5541
www.cuno.com
CAUTION
To reduce the risk associated with property
damage due to water leakage:
• Read and follow Use Instructions before
installation and use of this system.
• Installation and use MUST comply with all
state and local plumbing codes.
• Do not install if water pressure exceeds
120 psi (827 kPa). If your water pressure
exceeds 80 psi, you must install a
pressure limiting valve. Contact a plumbing
professional if you are uncertain how to
check your water pressure.
• Do not install where water hammer
conditions may occur. If water hammer
conditions exist you must install a water
hammer arrester. Contact a plumbing
professional if you are uncertain how to
check for this condition.
• Do not install on hot water supply lines.
The maximum operating water temperature
of this filter system is 100°F (37.8°C).
• Protect filter from freezing. Drain filter when
temperatures drop below 40°F (4.4°C).
• The disposable filter cartridge MUST be
replaced every 6 months, at the rated
capacity or if a noticeable reduction in flow
rate occurs.
• Protect from freezing, remove filter
cartridge when temperatures are expected
to drop below 33° F.
• Do not install systems in areas where
ambient temperatures may go above
110° F (43.3° C).
• Where a backflow prevention device is
installed on a water system, a device
for controlling pressure due to thermal
expansion must be installed.
• Ensure all tubing and fittings are secure and
free of leaks.