Light Kit Assembly; Important - Craftmade La Playa Guia De Instalacion

10. Light Kit Assembly.

IMPORTANT: Any light kit purchased for use
with this fan MUST be APPROVED for WET
LOCATIONS or OUTDOOR USE.
Remove 1 screw from post located in middle
of switch housing plate and partially loosen
the other 2 screws on the other 2 posts.
Connect male plug from motor housing to
female plug from light kit fitter. Connect
male plug (small) from the switch housing
plate to female plug (small) from the light kit
fitter. Make sure plugs connect tightly. Align
slotted holes in light kit fitter with loosened
screws in switch housing plate. Twist light kit
fitter to lock. Re-insert screw previously
removed and tighten all 3 screws securely.
Remove finial, finial plate and threaded
washer from light kit fitter.
Install 3 candelabra base 40 watt max. bulbs
(included).
Important: When replacing bulbs, please
allow bulbs and glass shade to cool down
before touching them.
Raise glass shade in order to guide pull
chains through corresponding holes. Align
threaded rod on light kit fitter with hole in
middle of glass shade and push up gently
allowing threaded rod to come through hole.
(Be sure pull chain for fan operation does not
rub against bulb during operation.) Secure
glass shade with threaded washer. Note: Do
NOT overtighten threaded washer as glass
may crack or break. Align hole in center of
finial plate with threaded rod, allowing pull
chains to come through appropriate holes in
finial plate, and push up. Thread center pull
chain through hole in finial and re-attach
finial. Note: Do NOT overtighten finial as glass
may crack or break.
post
male plug (small)
female plug (small)
threaded washer
finial plate
finial
pull chains
glass shade
page 8
switch
housing
plate
male plug (large)
female plug (large)
light kit fitter
bulb
threaded washer
finial plate
finial