Blade Assembly; Light Kit Assembly (Optional). Pgs - Craftmade ELLINGTON WOD52ABZ5PC1 Guia De Instalacion

8. Blade Assembly.

Time Saver: Washers for blade screws can be set
on each blade screw prior to installing blades.
Locate 15 blade attachment screws and washers
in one of the hardware packs. Hold blade arm up
to blade and align holes. (Be sure to install blades
with ridged-side facing up and flat side facing the
floor). Insert 3 blade attachment screws (along
with washers) with fingers first and then tighten
screws securely with a Phillips screwdriver. Repeat
procedure for the remaining blades.
Remove blade arm screws and lock washers from
underside of motor. If plastic motor locks are
installed with blade arm screws, discard plastic
motor locks (save blade arm screws and lock
washers to secure blade arms). Align blade arm
holes with motor screw holes and attach blade
arm with lock washers and blade arm screws.
Before securing screws permanently, repeat this
procedure with remaining blade arms. Securely
tighten all screws.
Note: Tighten blade arm screws twice a year.
9. Light Kit Assembly (Optional).
Remove 3 screws from switch housing cap (at top of
light kit fitter).
If you wish to use your fan WITH the light kit,
locate BLACK (or BLUE) and WHITE wires in switch
housing labeled FOR LIGHT KIT CONNECTION.
Remove and discard plastic that holds these 2 wires
together.
Connect WHITE wire from switch housing to WHITE
wire from light kit fitter. Connect BLACK (or BLUE)
wire from switch housing to BLACK wire from light
kit fitter. Be sure that molex connections snap
together completely.
Align holes in switch housing cap with holes in
switch housing. Re-insert screws that were previously
removed. ( Note: The gap on the edge of the switch
housing cap must align with the reverse switch on the
switch housing for the proper fit.) Secure all 3 screws
with a Phillips screwdriver.
["Light Kit Assembly" continued on next page.]
plastic
motor
lock
lock washers
molex
connections
page 7
motor housing
blade
blade arm
blade arm
screws
motor housing
switch housing
switch housing cap
light kit fitter