Light Kit Assembly - Craftmade Ventura VEN52 Guia De Instalacion

9. Light Kit Assembly.

Remove 1 screw from motor plate on
underside of motor and partially loosen the
other 2 screws. Align slotted holes in shade
with loosened screws in motor plate, allowing
molex plugs from motor housing to come
through hole in middle of shade. Twist shade
to lock. Re-insert screw that was previously
removed and securely tighten all 3 screws
with a Phillips screwdriver.
Remove 1 screw from underside of shade and
partially loosen the other 2 screws. Connect
WHITE wire from motor housing to WHITE
wire from LED light kit . Connect BLACK wire
from motor housing to BLACK wire from LED
light kit. Be sure molex connections snap
together securely. [Note: If you will NOT be
using the light kit, do NOT connect the plugs.]
Carefully arrange wiring within the back of
LED light kit. Align slotted holes in LED light
kit with loosened screws in shade. Twist LED
light kit to lock. Re-insert screw that was
previously removed and securely tighten all
3 screws.
Locate slots on LED light kit and align with
small posts on edge of light kit frame.
light kit frame to the RIGHT (clockwise) until
it locks into place.
CAUTION: Do not connect the LED light kit if
you do NOT wish to use the light.
motor plate
Turn
shade
LED light kit
light kit frame
page 8
motor housing
screws
molex
connections
screw
shade
molex
connections
slots