Auto Flash Mode A - Metz SCA 3102 M5 Manual Del Usuario

camera.
mecablitz 45 CL-4 digital
• Set the flash device to E-TTL or manual flash
mode (see operating instructions of the flash
device).
• Press the "mode" button until "HSS" appears in
the display.
mecablitz 54 MZ-...:
• Press the "mode" button until "TTL" or "M" flas-
hes in the display. If TTL or "M" no longer flas-
hes, press the mode button once.
• While "TTL" or "M" is flashing, turn the dial until
"ETTL" is shown in the display. "M" and "HSS"
appears in the display.
• To save the setting press the dial towards the
arrow; if the dial is not pressed, the setting will
be saved automatically after 5 seconds. After
saving, the "TTL" or "M" stops flashing.

3.4 Auto flash mode A

A sensor inside the mecablitz controls the light
output in auto flash mode "A": When the amount of
light required for correct exposure has been
reached, the mecablitz electronics automatically
cut off the flash. The correct exposure indication
"ok" appears on the mecablitz. For auto flash
mode, the mecablitz must be set to "A".
mecablitz 60 CT-4, 45 CL-4:
Set on the mecablitz an auto working aperture that
suits the prevailing shooting conditions: Take the
shooting distance into account and use the
aperture calculator on the mecablitz to determine
15