Quick Start - Calpeda EASYMAT Instrucciones Originales De Uso

GB
Before start the system, read the
frequency converter instructions
for the electrical connections.
1. Start
As soon as the EASYMAT is turned on, after an
inital check of the system the display shows
Er06, it will be necessary to set the motor
parameters on the frequency converter with the
following parameters:
- UP02
nominal current
- UP03
nominal frequency
- UP05
set point pressure
2. UP02 nominal current
(see also diagram chapter 23)
Push the buttons
with the button (plus) move to the parameter
UP02
. Confirm with
the buttons (plus) or
nominal current of the electric pump that you can
read on the data plate and confirm with
(enter). By pushing the button
out from the parameter.
3. UP03 nominal frequency
(see also diagram chapter 23)
Push the buttons
with the button (plus) move to the parameter
UP03
. Confirm with
the buttons (plus) or
nominal frequency of the electric pump that you
can read on the data plate and confirm with
(enter). By pushing the button
out from the parameter.

QUICK START

Single pump mode
(menu) and (enter),
(enter) and then with
(minus) set the
(menu) go
(menu) and (enter),
(enter) and then with
(minus) set the
(menu) go
4. UP05 set point pressure
Push the buttons
By pushing the buttons
move to the parameter
(enter) to enter parameter. With the buttons
(plus) or
pressure and confirm with
Exit from the program by pushing
until you arrive on the basic screen (the set-up
mode icon disappear).
Now the frequency converter is ready to run,
push the button
status from STOP to run.
When the motor starts turning, check
the direction of rotation of the pump.
5. Inversion of the direction of
rotation
motor)
To change the direction of rotation of the motor,
push the button
button (plus) move up to the programming
parameter UP. Confirm with
with the button
UP04
parameter
pushing of the button
value, confirm with
To exit the program, push
reach the basic screen, when you are out from
the set-up mode the icon disappear
Now you can start the frequency converter by
pushing the button
16
(menu) and
(plus) or
UP05
and confirm with
(minus) change the set point
(enter).
(play) to change the pump
UP04
(three-phase
(menu) and then with the
(enter) and
(plus) move up to the
, confirm with enter and by
(plus) change the
(enter).
(menu) until you
(play).
(enter).
(minus)
(menu)
.