Useful Information - Stylies Libra Instrucciones De Uso

USEFUL INFORMATION:

Information on how an ultrasonic vaporiser works
How does the ultrasonic vaporiser work? An ultrasonic membrane in the interior of the device
causes the water to oscillate, causing very ine droplets of water to be "catapulted of" from the
water surface. These droplets mix with the air in the spray chamber and are then blown into the
room through a ventilator as a visible spray. This ine spray evaporates in the warm air in the room,
moistening the air that people breathe.
White dust:
The ultrasonic vaporiser's method of action causes all substances contained in the water to be
sprayed, including calcium carbonate (a cause of limescale) and minerals. In order to prevent this as
far possible, the water is fed through the ilter cartridge before being sprayed. The cartridge retains
a large percentage of the substances contained in the water. Tap water varies greatly from region
to region in terms of its calcium and mineral content. Some minerals cannot be suiciently iltered
by the descaling resin used. In this case, a white, dust-like deposit is left in the room, which is irst
visible on electro-statically charged surfaces (such as TV sets). This deposit also occurs when the
ilter cartridge needs replacing (see the chapter on "Filter Cartridge and Water Hardness").
Tips for water
Do not use water that has been subject to salt-based softening in a descaling system. These sys-
tems replace the calcium with salt, which then settles in the room as a white deposit.
Clean water must always be used to ensure that the air remains hygienic to breathe. The device, and
the water tank in particular, must always be hygienically clean.
Recommendation: always use the Ionic Silver Cube™, as this reduces the formation of germs in the
water.
TROUBLE-SHOOTING
Control display does not go out after tank has been illed with water:
The device switches of automatically if there is insuicient water. The colour of the light diode (on
the front) then changes from green to red. To restart the generation of spray, the device must irst
be switched of and then switched back on again (this resets the device). This is a protective function
for the ultrasonic vaporiser.
Device does not switch on although the water tank has been attached and the on-button has been
pressed:
This is not a malfunction. It can take several minutes before suicient water for operation has run
from the water tank through the cartridge and into the base. Wait and then press the on-button
again.
The water tank is leaking:
Unscrew the lid, screw the cartridge in irmly and screw the lid back on to the tank.
Low performance, no steam output, device not functional:
Maintenance in accordance with the chapter on "Cleaning Procedure"
REPAIRS / DISPOSAL
• Repairs to all electric devices (including replacement of the power cable) may only be per-
formed by instructed experts. Carrying out inappropriate repairs voids the warranty and no
liability shall be accepted.
If the power cable has become damaged, it must be replaced by the manufacturer, his oicial
•
service partner or a qualiied person, in order for further damage to be avoided.
• Never operate the device if the cable or the plug is damaged, after the device has malfunc-
tioned, if it has been dropped or if it has been damaged in any other way (i.e. with cracks or
breakages to the housing).
• Do not use any sharp, abrasive objects or corrosive chemicals.
• Disable devices that are to be discarded immediately (by cutting of the power cable) and dis-
11