Lamp (Re)Placement - Briteq BT-Strobe 3000 Manual De Instrucciones

ENGLISH
 Never repair a fuse or bypass the fuse holder. Always replace a damaged fuse with a fuse of the same
type and electrical specifications!
 In the event of serious operating problems, stop using the fixture and contact your dealer immediately.
 The housing and the lenses must be replaced if they are visibly damaged.
 Please use the original packing when the device is to be transported.
 Due to safety reasons it is prohibited to make unauthorized modifications to the unit.
Important: Never look directly into the light source! Don't use the effect in the presence of persons suffering
from epilepsy.
DESCRIPTION:
1. MAINS CABLE: must be fitted with
a heavy duty mains plug with
ground connection.
 Brown wire: live, marked "L"
 Blue wire: neutral, marked "N"
 Yellow/green wire: ground.
2. AUTOMATIC FUSE: press this
button to reset.
3. HANGING BRACKET with knobs
on both sides to fasten the unit and
a mounting hole to fix a mounting
hook.
4. MENU button: used to select the
different menu items
5. UP/DOWN buttons: to go back/forward in the menu and to lower/increase the values shown on the
display.
6. ENTER button: used to confirm your choice.
7. DISPLAY shows the various menus and the selected functions.
8. FLASH INDICATOR: flashes in the same rhythm as the lamp.
9. DMX LED: is lit when the unit receives a DMX-signal
10. DMX IN/OUTPUTS: used for DMX512 linking, you can use good quality balanced signal cables with 3pin
or 5pin XLR-connectors.

LAMP (RE)PLACEMENT

Strobe tubes should be replaced by qualified technicians only !
Strobe tubes contain poisonous chemicals. Discard used strobe tubes appropriately.
Keep out of reach of children and animals.
 Disconnected the unit from the mains.
 Make sure the unit has cooled down completely.
 Loosen the 2 screws on both sides of the unit (see "*" on the
drawing) and open the front glass cover.
 Disconnect the lamp wires from the screw terminals
 Remove the old lamp from the lamp holders.
 Press the new lamp gently in lamp holders.
 To avoid burned wires: make sure that the lamp wires are as far as
possible from the lamp glass.
 Connect the lamp wires to the screw terminals
 Close the unit again and fasten the 2 screws marked "*"
BRITEQ
®
3/42
USER MANUAL
BT-STROBE 3000