22 English
Table 3
Power supply specifications
Internal power supply
50 W AC
Secure Router 2330 grounding specifications
The Secure Router 2330 ships with a grounding lug. You must connect
your ground wire to the lug, and attach the lug to the chassis in the
right-hand side of the front panel. You must attach the other end of
the ground wire to the most convenient site grounding point for your
installation. Use a maximum of 8 AWG grounding cable for the Secure
Router 2330.
ATTENTION
Nortel recommends that you install the chassis in the equipment rack before you
install the ground lug and the optional external interface modules.
Secure Router 4134 power and grounding
Secure Router 4134 power specifications
The following table describes the Secure Router 4134 chassis AC and DC
power supply units.
Table 4
Power supply specifications
Power supply
250 W AC
660 W AC
250 W DC
Input
100-240 V AC
CAUTION
Ensure you use an appropriately rated AC power cord only. Do
not use an extension cord.
Input
100-240 V AC
100-240 V AC
-40 to -72 V DC
Nortel Secure Router 2330/4134
Regulatory Information
NN47263-106 01.01 18 September 2009
Copyright © 2009- Nortel Networks. All Rights Reserved.
Output to router
components
+12 V DC
Output to router
components
+12 V DC at 250
Watts (20.83 Amp
at nominal voltage)
+12 V DC at 250
Watts (20.83 Amp
at nominal voltage)
+12 V DC at 250
Watts (20.83 Amp
at nominal voltage)
PoE output
N/A
+54 V DC at 410
Watts (8.2 Amp at +54
V DC) (isolated from
the +12 V DC output)
N/A