Procedure steps
Step
Action
1
Remove the Secure Router 2330 top cover. See Removing the
Secure Router 2330 top cover.
2
Locate the internal PVIM module connector slot.
See the following figure for reference.
3
Ensure the PVIM slot is clear of debris. Protective tape is placed
over the SO-DIMM and PVIM slots during the manufacturing
process; remove this tape if it is present.
4
Holding the PVIM by its edges, insert the module in the slot on
the Main Board, pushing down gently, but firmly, to fully seat the
module. The release latches close when the PVIM is properly
installed.
Removing the Secure Router 2330 internal PVIM module
Use the procedure in this section to remove a PVIM module from the
Secure Router 2330.
Nortel Secure Router 2330/4134
Regulatory Information
NN47263-106 01.01 18 September 2009
Copyright © 2009- Nortel Networks. All Rights Reserved.
Secure Router 2330/4134 modules 29
DANGER
Do not open the Secure Router 2330 top cover while
the unit is powered.
--End--