34 English
Procedure steps
Step
1
2
3
4
Installing the Secure Router 4134 internal PVM
Use the procedure in this section to install an internal PVM.
Action
Remove the Secure Router 4134 service access panel. See
Removing the Secure Router 4134 service access panel.
DANGER
Do not open the Secure Router 4134 service access
panel while the unit is powered.
Remove the two screws that secure the VPN/IPSec module to
the Main Board (see the following figure).
Grasping the edges of the VPN/IPSec module, pull the module
up and out of the slot in which it is seated.
If you are not installing a VPN/IPSec module at this time, replace
the service access panel.
Nortel Secure Router 2330/4134
Regulatory Information
NN47263-106 01.01 18 September 2009
Copyright © 2009- Nortel Networks. All Rights Reserved.
--End--