Residual Risks - Eco MODINE EGK Serie Manual Tecnico

12. Residual risks

12.1 The equipment presents a number of risks that have not been fully eliminated from the design point of view or
through the installation of adequate protections. Based on such risks, it is reported which PPE should be used
by the operators or which behaviours and procedures should be adopted.
During installation of the equipment ensure sufficient space to limit these risks. To preserve such conditions, the
corridors and areas surrounding the equipment must always:
• be kept free from obstacles (such as ladders, tools, containers, boxes);
• be clean and dry;
• be well lit if necessary.
List of residual risks that remain in relation to the equipment
BURN
ELECTROCUTION:
SHARP FINS
CUTTING AND CRUSHING BY BODIES IN MOTION
60
www.modine.com
The operator (in particular situations or during maintenance)
intentionally or unintentionally touches a hot or frozen
surface: if necessary use insulating gloves and/or wait for
cooling/heating of the surfaces.
Contact with live electrical parts during maintenance
operations carried out with the presence of voltage: operations
reserved for qualified and authorised operators, equipped
optionally with PPE and insulating tools - in general turning
off the power supply to the machine by placing in the open
position "O" the main switch and locking it in this position.
The operator at the stages of use and cleaning must be
careful of the fins as they are sharp.
The operator (in particular situations or during maintenance)
must pay attention to the fans. In general disconnect the fan
by placing the safety switch located at the opening in the
open position "O".