Introduction - ProTeam GoCartVac Manual Del Usuario

Ocultar thumbs Ver también para GoCartVac:
Tabla de contenido

Publicidad

Idiomas disponibles

Idiomas disponibles

The ProTeam GoCartVac gives the convenience of a cart cleaning platform with the additional
convenience of cordless vacuuming. The GoCartVac can also be plugged in to a 120V wall out-
let to run directly off AC power. While running on AC power, the batteries for the GoCart Vac
will also be recharged.
The vacuum is conveniently controlled by toggling the on/off switch on the gas pump style
handle at the end of the hose.
See the "CHARGING THE BATTERIES" section for more information on charging and run times.
BATTERY RECYCLING
The Environmental Protection Agency requires the recycling of sealed lead batteries. Proper
disposal and recycling of batteries mandatory under the Mercury-Containing Rechargeable
Battery Management Act, 42 U.S.C 14301-14336 ("Battery Act").
WARNING
DO NOT charge batteries with a frayed, worn, or damaged cord.
DO NOT vacuum liquids or expose the vacuum to rain or water.
DO NOT vacuum hazardous or toxic materials.
DO NOT use vacuums to pick up flammable or combustible materials and DO NOT
store them in the filter bag.
MOTOR
Electric thru-flow vacuum motors must never be used in applications in which wet or moist
conditions are involved, where dry chemicals or other volatile materials are present, or where
airflow may be restricted or blocked. Such motors are designed to permit the vacuumed air to
pass over the electrical wiring to cool it. Therefore, any liquid (including water), dry chemical,
or other foreign substance which would come in contact with electrical conductors could cause
combustion (depending on volatility) or electrical shock. Failure to observe these precautions
could result in property damage and personal injury, including death in extreme cases.
ELECTRICAL
Follow all instructions and warnings for charging the batteries.
Each vacuum cleaner described in this manual is equipped with a thermal protection cutoff
switch which will remove power from the vacuum motor if excessively high operating tem-
peratures are detected. This condition may arise as the result of a blocked vacuum passage, or
clogged or full filters.
If a thermal trip takes place, immediately toggle the vacuum's switch to OFF and inspect for an
airflow blockage in the hose and verify the condition of the filter bag. Replace or empty the
filter bag as required. The vacuum will require several minutes to cool down to a safe operating
temperature. When this temperature is attained, the thermal switch will reset and the vacuum
will be able to be used in the normal manner.
ProTeam

INTRODUCTION

USE ONLY genuine ProTeam replacement filters to ensure
optimal performance, achieve improved indoor air quality,
and to maintain a valid vacuum warranty.
3

Publicidad

Tabla de contenido
loading

Este manual también es adecuado para:

1060870

Tabla de contenido