Operation - Vollrath 40834 Manual Para Operadores

OPERATION

The machine includes 20 default programs. These programs can be
named and the settings customized for specific needs. See Create
Custom Programs and Labels on page 4 for instructions.
NOTICE: Never pack products that can be damaged by vacuum
packaging.
NOTICE: To reduce condensation and corrosion risk for the pump,
cool products before packing.
NOTICE: When packing food, always select a program that includes
Liquid Sensor Control.
NOTICE: Special instructions apply for packing liquid products. See
Packing Liquid Products on page 3.
NOTICE: The machine is designed for a maximum use of five hours
per day.
NOTICE: This machine is not designed for continuous use. Allow 15
seconds between packing cycles.
NOTICE: If the machine has been in use for one hour, stop the
machine and allow it to cool to ambient temperature.
NOTICE: Do NOT tilt the machine. Tilting could enable oil to flow out
of the pump and cause damage to the machine.
Turn On the Machine
1. Rotate the lid retainer so it is not covering the lid. The lid retainer is
used only for securing the lid when the machine is not in use.
2. Press and release the On/Off button and allow approximately 7-10
seconds for the display to load.
3. If the machine has not been used for a while, run the Pump
Conditioning Program. See page 7.
Select a Program
Packing a Food Product: Select a program that includes Liquid Sensor
Control.
Packing a Liquid Product: See important information under Packing
Liquid Products on page 3.
1. Press  or  to select a program.
Press  or  to view the functions in the program.
2. Press to view the settings of a function. For descriptions of the
functions, please see page 4
Vacuum Packing Machine with Dual 16" Sealing Bars and Advanced Control System (ACS) Operator's Manual
.
Place the Product in the Chamber
CAUTION
Burn Hazard
Sealing bar may become hot after repeated use. Do not touch
the sealing bar when placing vacuum bags in the chamber.
1. Place the food product in a vacuum sealing bag that fits completely
within the chamber.
2. Place the bag in the chamber with the open end over the sealing
bar. Make sure the bag is smooth, without wrinkles or folds.
3. For small products, place one or more insert plates under the
product. This fills empty space in the chamber, which reduces the
cycle time.
4. Multiple vacuum bags can be placed over the sealing bars. Do NOT
overlap vacuum bags.
Run the Program
1. Close the lid. Do NOT use the lid retainer. Using the lid retainer
during a packing cycle will interfere with the cycle.
2. The program automatically starts.
3. The lid opens when the last function is complete.
4. Remove the packed product.
5. Wait 15 seconds before packing another product.
Stop a Cycle
• Stop the vacuum function and continue to the next function,
press .
• Stop and cancel the entire cycle Press
Packing Liquid Products
Special care needs to be taken when vacuum packing liquid or moist
products.
• Cool foods before packing. Hot food quickly reaches the boiling
point, which can lead to an insufficient seal.
NOTICE: Hot products create condensation, which can damage
the pump.
1. Use the included incline plate and magnetic positioning bars to
position the bag so the liquid is below the sealing bar. Magnetic
bars are shipped attached to the underside of the incline plate.
2. Use a program that includes the Liquid Sensor Control function.
This will prevent the product from boiling.
NOTICE: Boiling will increase the amount of moisture that enters
the pump, which can lead to corrosion.
3. Run the Pump Conditioning Program at the end of the work day.
See page 7.
stop
Magnetic bar
Incline plate
3