Operation; General; Control Panel; Operating The Unit - Hatco RWM Serie Manual De Instalación Y Funcionamiento

General

Hatco Waffle Makers are designed for ease of operation and
versatility. Use the following information and procedures to
operate a waffle maker.
WARNING
Read all safety messages in the IMPORTANT SAFETY
INFORMATION section before operating this equipment.

Control Panel

The following are descriptions of the controls used to operate a
Waffle Maker. Controls are located on the control panel as well
as on the back of the unit.
Power I/O Switch
The Power I/O (on/off) switch controls power to the unit. It is
located on the back of the unit. Use the Power I/O switch for
daily or long-term shutdown of the unit.
LED Display
The LED display shows time, temperature, and error information
for the waffle maker.
Standby Button
The lighted Standby button (
operating mode and standby mode. Use standby mode for short-
term shutdown of the unit.
• In standby mode, the light will be red.
• In operating mode, the light will be green.
Time/Temperature Button
The Time/Temperature button (
through temperature and time settings.
Arrow Buttons
The Arrow buttons (
temperature settings.
• Press the button to increase a time or temperature
setting.
• Press the button to decrease a time or temperature
setting.
Enter Button
The Enter button ( ) starts a cooking cycle and resets the
timer at the end of a cycle.
Standby Button
Time/Temperature Button
Form No. WMCEM-0519
) toggles the unit between
) toggles the LED display
) are used to change time and
LED Display

Operating the Unit

Startup
1. Plug the unit into a properly grounded electrical receptacle
of the correct voltage, size, and plug configuration. See the
SPECIFICATIONS section for details.
NOTE: The unit is preset at the factory to a temperature of 196°C
(385°F) and a timer setting of 3:30. The temperature
range of the unit is 104°–218°C (220°–425°F). The
timer setting range of the unit is 00:10–10:00. Refer to
procedures in this section to make adjustments to these
settings.
2. Make sure the drip tray is in position on the bottom cooking
plate.
Installing Drip Tray
Drip Tray
Bottom
Cooking
Plate
Installing the Drip Tray (RWM-1 shown)
BURN HAZARD:
• Some exterior surfaces on unit will get hot. Avoid
unnecessary contact with unit.
• Do not come in contact with cooking plates during
operation. Both plates are very hot.
3. Move the Power I/O switch located
on the back of the unit to the "I" (on)
position to turn on power to the unit.
• A beep will sound, the LED
display will flash, and the light on
the button will illuminate from
green to red.
Enter Button
Control Panel
7

OPERATION

Drip Tray Installed
CAUTION
Arrow Buttons
Power I/O
Switch
continued...