Aetertek AT-211D Manual Del Usuario página 5

Quick Start
Dog 0,1 or 2 Icon:
0 means both dogs;
1 means the 1st dog;
2 means the 2nd dog.
5
Step 5:
Match the receiver and transmitter. Choose the
dog mode (Dog1, dog2 or dog00) by pushing the M button .
For the first receiver, choose dog 1 and quick press one of the
three buttons on the front , the first receiver will be connected
with the remote along with red light turns off and blue light
starts flash. If you have another receiver, turn it on and choose
dog 2, press any fuction buttons. The second receiver will be
paired; You can train different dogs separately in different dog
system. If Dog00 is selected, both dogs will receive
correctional signals.
Shock Button
Beep Button
6
-03-
M Button
Quick press one by one
time will choose 0,1 or 2
dog system;
Vibrate Button
Step 6:
Check the button functions. Push the beep button,
and the receiver beeps. Similarly,press the vibrate button, and
the receiver vibrates. Cap the shock test kit on the metal prongs,
and press the shock button. If the bulb lights up, the shock
function is normal.
Push up M button will increase shock
Shock Level
level;
push down M button will reduce shock
level;
7
Step 7:
Press the M button up or down to increase or decrease
shock level. There are 10 available levels.
The duration for pressing the beep, vibrate or shock button will
Tip 4:
lead to difference on the length of the beep, vibration or shock time.
Step8:
Start to train the dogs. Put the collar into the receiver and
wear the receiver around dog's neck. Remember to leave one finger
place between the collar and the neck, and then you can train the dogs.