Installation - Walker W-300 Guia Del Usuario

Warning: To prevent electrical shock,
always remove the telephone line cord
from the wall jack before removing the
cord from the telephone. Never leave the
line cord connected to the wall jack if it is
not also connected to the telephone.
AC adapter should be unplugged when not
in use.
➤ Select a Location:
• This unit requires a modular phone jack
and a standard 120 volt outlet.
• The unit should be located in an area
where it is easy to see the lighted ringer.
• The unit can be used as a desk top
phone or a wall mount phone.
➤ Connecting
Your Walker W-300
The Walker W-300 can be used as a desk
or wall telephone.
To install as a Desk Unit:
• Insert AC Adapter into the jack located
on the top side of the telephone.

INSTALLATION

• Locate the hinge slots located on the
right and left side of the back of the
telephone.
• Turn wall mount bracket so the wide end
(end with rubber feet) of the bracket is
towards the top.
• Install bracket by inserting the tabs on
the bracket into the hinge slots.
• Press down on the top of the bracket to
lock into place.
• Plug AC Power Adapter directly into
standard 120 volt outlet.
• Plug one end of the telephone line
cord (flat) into the back of the Walker
telephone.
• Plug the other end of the telephone line
cord into the wall jack.
• Plug one end of the handset cord (coiled)
into the bottom of the handset.
• Plug other end of handset cord into the
jack located on the lower left side of the
telephone and hang up receiver.
• The unit should sit on an angle when
used as a desk phone.
E
N
G
L
I
S
H
7