Electrical Connection - Pando E-225 Guia Instalacion

E-225 INSTALLATION MANUAL
ELECTRICAL CONNECTION: (To be carried out exclusively by qualified professionals).
PRECAUTION! During the installation and the subsequent performance of any operation
inside the extractor hood or maintenance, ensure that you first disconnect the appliance
from the mains.
The mains power supply voltage must be stable and under the electrical requirements listed
(see nameplate on the appliance).
The hood electrical connection must be connected to a separate network power line to the
electrical panel, in order to prevent any interference in the hood from fluorescent procedures or
other devices that transmit noise in the network.
Leave the disconnection of the mains plug to the device socket, otherwise, add a switch to the
electrical installation in accordance with the electrical installation regulation.
The connection must be performed in accordance with the provisions of law in force.
Before connecting the Extractor Hood, ensure that the hood and mains voltage match (see
nameplate on the inside of the appliance).
We decline any responsibility in case of an accident caused by a failure to earth or by a faulty
earthing. If the power cord is damaged, call our official after-sales service to prevent any risk
of danger.
The appliance must be disconnected from the mains when carrying out any installation and
maintenance operations.
ANUAL DE INSTALACIÓN DE LA E-250, E-260, E-270 V1000
Interpretation of the power supply wires:
Green / Yellow = Earthing
Blue = Neutral
Brown = Line / phase
Page 5