Electronic Control Board Reset Procedure - CUOGHI NEB6500 Manual Del Usuario

5.4 Electronic control board reset procedure

In some cases an anomalous working of the electronic board may appear, and can be necessary to execute the following reset procedure:
•
Switch off the main power supply of the machine, opening the main switch on the control box.
•
Position the potentiometer on the first notch after the 100%
•
Pressing the push button located on the right of the potentiometer, switch on the power;
Release the button after some seconds: the electronic board confirms the reset with seven red flashes.
•
-Switch off the main power and, after some seconds, switch it on again, verifying that the red led flashes seven times; after the
seven flashes switch off the main power.
It is very important to switch off the main power after the seven flashes as, if the humidistat gives the signal,
after some seconds the machine starts (see: 5.3 The washing/reset cycle)
•
Set the desired humidification capacity, as written on paragraph 5.2 Adjusting the humidification capacity, before closing the
humidifier to restart standard operation.
M360-4-GB - 16 -
E L E C T R O N I C C O N T R O L