Adjusting The Disc Guard Cover; Using The Auxiliary Handle; Maintenance And Cleaning - Parkside PWS 1010 Instrucciones De Utilización Y De Seguridad

Use of accessories / Maintenance and cleaning
Note! These may only be used in combination
with a backing plate!
Cup brush, crimped wire
Dimensions:
Speed:
Cup brush, twisted wire
Dimensions:
Speed:
Cup brush, knotted wire
Dimensions:
Speed:
©

Adjusting the disc guard cover

½
WARNING!
Pull the mains plug out of the mains socket
before you carry out any task on the device.
DANGER OF INJURY! Always use the an-
gle grinder with the disc guard cover
place. The disc guard cover must be securely
attached to the angle grinder. To ensure the
60 GB/MT
ø 75 - 100 mm
min. 12.000 rpm
ø 75 mm
min. 12.000 rpm
ø 115 mm
min. 12.000 rpm
DANGER OF INJURY!
in
5
highest level of safety while using the device,
ensure that the smallest possible area of the
grinding or cutting tool is exposed to the oper-
ator at all times (see Fig. B, C). The disc guard
cover is there to protect the operator from
5
pieces breaking off and accidental contact
with the grinding or cutting tool. The disc guard
cover has 5 set positions.
Turn the disc guard cover
position (working position). The closed side of
the disc guard cover
the operator.
©

Using the auxiliary handle

CAUTION! For safety reasons this device
must always be used with the auxiliary handle
in place. The auxiliary handle
on to the left, right or on the top of the head of the
device.
©

Maintenance and cleaning

½
WARNING!
Pull the mains plug out of the mains socket
before you carry out any task on the device.
½
Do not use sharp objects for cleaning
the device. Do not allow any liquids
to enter the device. Otherwise the tool may
be damaged.
Have the carbon brushes replaced only at the
service centre or an accredited electrical
equipment repair centre. The device requires
no other maintenance.
Clean the device frequently; for best results do
this immediately after you have finished using it.
Use a dry cloth to clean the housing – under
no circumstances use petrol, solvents or clean-
ing agents that attack plastic.
A vacuum cleaner is required to thoroughly
clean the device.
Ventilation openings must always be kept free.
Remove any adhering dust with a narrow paint
brush.
into the desired
5
must always be facing
5
can be screwed
4
DANGER OF INJURY!
4