GPO WINCHESTER Manual Del Usario página 15

1. Press "Function" button and switch into FM mode.
2. To scan stations manually, rotate "Tune +/- " knob to adjust stations
by 0.05MHZ until you get your favorite stations.
3. To auto scan stations, press " Scan" button to search stations , if
station signal is available, scan will stop automatically and the radio
will play this station. Press "Scan" button, it will activate a full station
search. A progressive bar will show the progress of the scan and the
number of stations found during the scan. The stations scanned will
be stored automatically when the scan is complete.
4. You can rotate " Tune +/- " to switch among stations stored.
5. Rotate "Volume +/-" to adjust the volume.
6. To store a station preset, you must first tune to the station you wish
to set as a preset. Then press "Preset" button to activate store
function. "Preset Empty 1" will be displayed on lower line of the
screen, and the number "1" will flash. Rotate "Tune +/- " to scroll
through the numbered preset locations (1-20), press and hold
"Select" button to store the station. Frequency will be displayed
on the upper line. "Preset x Stored" will be shown on the screen
to indicate after you store the station successfully. 20 stations can
be stored in total. To tune to a preset FM station, use "Tune +/- " to
scroll through the preset stations. Press "Select" button or wait a few
seconds to confirm when you see the station you would like to listen
to. The radio will begin to play. If you have already saved a station
in that preset position, the new selection will override the previous
saved station. Long press " Preset " button , you can review all the
stored stations.
7. In FM mode, press "INFO" button to display the information such as
RDS, audio type, station frequency, time and date, signal quality,
program text, program type.
GPO_Winchester_user_Manual EU - Sept 2018 V1.indd 15
15
10/09/2018 09:21