To Operate The Product; To Stop The Product; To Use The Throttle Control - Husqvarna ST 224 Manual De Usuario

To operate the product

CAUTION: Do not operate without snow
or water to lubricate the auger blades.
Incorrect use can cause high
temperatures in the auger blades,
especially if the product is new. This can
cause damage to the auger blades and
scraper bar.
CAUTION: Do not partially engage drive
or auger levers for an extended period of
time; this can lead to premature wear or
burning of the belts.
Note: When both the drive engagement and auger
engagement are engaged, the drive engagement will
lock the auger engagement in position. Use the right
hand to control the snow discharge chute.
Note: Do not change the speed when the drive lever
is engaged. This can cause damage to the
transmission.
1. To engage the auger blades, push the auger
engagement (A) to the handle to engage the
auger and throw snow.
2. Raise the drive speed control lever (B) from the
middle position to make the product move
forward when the drive engagement (C) is
engaged. Do not change the speed when the
drive lever is engaged. This can cause damage
to the transmission.
3. Lower the drive speed control lever from the
middle position to make the product move
rearward when the drive engagement is
engaged.
12
C
4. To make the product move in the selected
direction, hold the drive engagement (C) against
the handle .
5. If the product has power steering, hold the left
steering trigger (D) to turn left. Hold the right
steering trigger to turn right.
A

To stop the product

1. Move the ON/OFF switch to the OFF position (if
equipped).
2. Remove the ON/OFF key.

To use the throttle control

• Slide the throttle control (A) to change the
amount of fuel used. Always operate the engine
at full throttle.
B
D
1481 - 004 - 14.04.2021