Installation And Use - Tristar AT-5451 Manual De Usuario

INSTALLATION AND USE

• Take the appliance and accessories out the box. Remove the stickers,
protective foil or plastic from the device.
• Install the universal wheels: Take out the universal wheel and install
them on the air cooler.
• Pull out the water tank from the body for about 1/3 and pour water
into the tank. Make sure the power has been switched off for a
minimum of 2 minutes.
• Pay attention to the water line during filling. Make sure the water level is
not higher than the "MAX" water line and lower than the "MIN" water line.
• To increase the cooling effect, you can put the frozen ice box in the
water tank.
Attention: Do not connect the power cord with wet hands.
OPERATION
Function of the control panel
Button Function
On/off button Plug the unit into an electric outlet. Press the On/off
button to start running.
Timer button When the air cooler is running, press the Timer button
to preset the running time, each press will increase the
preset time with one hour.
Mode button Press the Mode button to choose between the different
airflow modes normal, naturel, sleep.
Ventilation level There are 3 different speed levels: Low /Medium /High,
button press this button and set the desired speed.
Button Function
Oscillation button Activate or deactivate the oscillation function.
Evaporator/cooler Press the evaporator/cooler button once, the unit will act
button as a evaporator now. If combined with Ice box, this unit
can lower its surrounding about 3°C.
Ice Box
• The ice box can lower the temperature of the water in the tank. It can
make the air flow cooler.
• Take out the ice box and put it in the freezer until the ice box is totally
frozen.
• Put the frozen ice box in the water tank.
Mode
Press button "MODE" when air cooler is working, you can choose between
the following different modes.
• Simulating natural wind: sometime strong, sometime weak.
• Slumberous wind: slumberous wind
a. 1st speed setting: keep working on 1st speed
b. 2nd speed setting: working in natural wind 2nd speed for
30 minutes, then change and keep working on 1st speed.
c. 3rd speed setting: working in natural wind 3rd speed for 30 minutes,
then change to natural wind 2nd speed for 30 minutes, then change
and keep working on 1st speed.
• Normal wind: the wind speed is fixed, when you choose like 2nd speed,
then it keeps working on 2nd speed setting.
Air cooler
EN
5