Troubleshooting (Type Rsg (**) And Rsg Ex (**)) - Fein RSG Ex 1500 A Manual Del Usuario

3 41 01 261 06 0.book Seite 25 Montag, 16. April 2018 12:03 12

Troubleshooting (type RSG (**) and RSG Ex (**)).

Fault
Motor and cutting tool stop
functioning
Defective chain wheel
Faulty cutting procedure
The function of the machine is reduced
or ineffective
Strong vibrations
Possible causes
Very low ambient temperatures
Blunt cutting tool
No mains voltage
Incorrect mains voltage
Advancement too fast or material removal
too high during one revolution
Oil loss in the gear box
Excessive temperature increase in the motor
Damaged chain link
Chain incorrectly joined
Chain bolt only partially inserted
Pipe milling machine and chain are not correctly
aligned
Guide shaft not eccentric
Blunt cutting tool
Pipe is laid at an incline or vertical,
or pipe is out of round
Cutting tool is overloaded
No mains voltage
Switch is not on
Coupling slips
Advancement too fast
Cutting tool too deep
Clamping lever (11) not tightened
Chain loose
Blunt cutting tool
Measures to be taken
Use FEIN gear oil for low temperatures
Change the cutting tool
Check the mains connection and switching
devices
Check the data for the mains connection
Align the gears and/or reduce the plunging
depth
Replenish oil. If oil loss occurs again,
look for leakage point and repair.
Reactivate the switchgear
combination 3 07 02 041 01 4
Change the chain link
Check the joins and correct
Fully insert the bolt
See Chapter „Preliminary work on the pipe mil-
ling machine (see Fig. A)." auf Page 20 and
Abschnitt „Clamping the pipe milling machine
onto the pipe." auf Page 20
Adjust the running accuracy, see Chapter „Set-
ting the running accuracy." auf Page 22
Change the cutting tool
Use the track guiding device, see Chapter
„Clamping the pipe milling machine onto the
pipe." auf Page 20 und Chapter „Track guiding"
auf Page 29
Align the gears and/or reduce the plunging
depth
Check the mains connection and switching
devices
Check switch
Align the gears or request the FEIN factory to
adjust the pick-up torque of the coupling
Align gears
Raise the cutting tool
Tighten nuts
Check chain tension
Chang the cutting tool
en
25