Connections To Be Made; From The Ld-Lcgm1-Rca Harness - Axxess AW-INGM1 Instrucciones De Instalación

Attention!
This interface will work with models that are either factory analog
amplified, or non-amplified. Please follow the instructions carefully for your model
vehicle. Failure to do so will result in either no sound, or low sound. If you are unsure
if your vehicle is factory amplified or not, please contact your local dealership.
From the LD-LCGM1-RCA harness to the aftermarket radio:
For models with a factory amplifier:
• Connect the Black wire to the ground wire.
• Connect the Yellow wire to the battery wire.
• Connect the Red wire to the accessory wire.
• Connect the Blue/White wire to the amp turn on wire.
• If the aftermarket radio has an illumination wire, connect the Orange wire to it.
Note: There are (2) Orange wires. If the Orange wire on the 24-pin harness is
populated on the factory side, use that wire. Otherwise, use the other Orange wire.
• Connect the Gray RCA jack to the right front RCA output.
• Connect the White RCA jack to the left front RCA output.
• Connect the Green RCA jack to the right rear RCA output.
• Connect the Purple RCA jack to the right rear RCA output.
The following (3) wires are only for multimedia/navigation radios that require these wires.
• Connect the Blue/Pink wire to the VSS/speed sense wire.
• Connect the Green/Purple wire to the reverse wire.
• Connect the Light Green wire to the parking brake wire.
AW-INGM1

Connections to be made

For the following (8) wires, cut off the RCA jack to expose the speaker wires.
The following (3) wires are only for multimedia/navigation radios that require these wires.
3
®
For models without a factory amplifier:
• Connect the Black wire to the ground wire.
• Connect the Yellow wire to the battery wire.
• Connect the Red wire to the accessory wire.
• Connect the Blue/White wire to the power antenna wire.
• If the aftermarket radio has an illumination wire, connect the Orange wire to it.
Note: There are (2) Orange wires. If the Orange wire on the 24-pin harness is
populated on the factory side, use that wire. Otherwise, use the other Orange wire.
• Connect the White wire to the left front positive speaker output.
• Connect the White/Black wire to the left front negative speaker output.
• Connect the Gray wire to the right front positive speaker output.
• Connect the Gray/Black wire to the right front negative speaker output.
• Connect the Green wire to the left rear positive speaker output.
• Connect the Green/Black wire to the left rear negative speaker output.
• Connect the Purple wire to the right rear positive speaker output.
• Connect the Purple/Black wire to the right rear negative speaker output.
• Connect the Blue/Pink wire to the VSS/speed sense wire.
• Connect the Green/Purple wire to the reverse wire.
• Connect the Light Green wire to the parking brake wire.
Continue to Installing the Axxess Interface