Power Stroke PSL1PS11 Manual Del Operador página 15

PROBLEM
Paint pattern is weak or uneven
NOTE: FIGURES (ILLUSTRATIONS) START ON PAGE 16
AFTER FRENCH AND SPANISH LANGUAGE SECTIONS.
TROUBLESHOOTING
CAUSE
Pressure is set too low
Pistol-grip sprayer or intake tube filter is
clogged
Intake tube is loose at inlet valve
Spray tip is worn
Material being sprayed is too thick
Loss of pressure
Page 15 — English
POSSIBLE SOLUTION
Turn variable pressure control to a higher
setting
Clean or replace filters
Tighten tube fitting
Replace spray tip
Follow material manufacturer's directions
and thin material as needed
See Cause/Possible solutions for Pressure
setting is too low, and Motor seems to
be running properly but pressure drops
when pistol-grip is triggered