Publicidad
Idiomas disponibles
Idiomas disponibles
To raise the drive wheel higher, push the micro-switch down.
To raise the drive wheel less, push the micro-switch up.
The manufacturer recommends setting the micro-switch so that the top edges of the housing
(3) are parallel to the interface (1) in the basic position.
If the micro-switch is not switched during raising, the unit will lower and raise again. An error
message is then issued via the TENTE control. The position of the micro- switch must then be
reset by pushing it up further).
WARNING
Risk of crushing by the interior parts of the device.
Never reach inside the device when it is connected to the control unit.
Remove the connection plug of the control unit before working on the device.
ATTENTION!
Incorrect setting of the micro switch causes malfunctions when resetting the emergency
release.
Ensure the correct setting of the micro switch.
Set the micro switch as described in the following section.
If you have any queries contact your sales partner.
Ensure that the device is disconnected from the power supply.
Release the two screws (2).
Push the micro switch (1) to the desired position.
Tighten the two screws (2) by hand.
Connect the device to the power supply.
Check if the drive wheel is lifted into the basic position.
Repeat the setting if the drive wheel is not lifted as desired.
27
Publicidad
