Emglo K15A-8P Manual De Instrucciones página 9

FEAturES
unloAdEr VAlVE
When the maximum air tank pressure is obtained, the unloader
valve (h) will blow-off. This will cause the compressor to exhaust
the air to the atmosphere and not the tank.
Manual lock: The manual lock allows you to manually unload the
compressor with air pressure in the air tank. To operate the manual
lock:
Rotate the manual lock unloader lever to the
open position to prevent air tank pressure
buildup. Rotate manual lock unloader lever to
the closed position after starting the motor to
allow air tank pressure to build. notE: Air will
not build in tank when manual lock unloader
lever is in the open position.
sAfEty VAlVE
This valve (I) is designed to prevent system failures
by relieving pressure from the system when the
compressed air reaches a predetermined level. The
valve is preset by the manufacturer and must not be
removed or modified in any way.
AIr IntAKE fIltEr
The filter (A) is designed to clean air entering the pump.
To ensure the pump continually receives a clean, cool,
and dry air supply the filter must always be clean and
the filter intake must be free from obstructions.
AIr tAnK drAIn VAlVEs
The drain valve (J) is used to remove
moisture from the air tank after the air
compressor is shut off.
AIr tAnK PrEssurE GAuGE
The air tank pressure gauge (D) indicates air
pressure in the air tank.
rEGulAtEd PrEssurE GAuGE
The regulated pressure gauge (E) indicates
h
h
the air pressure available at the outlet side of
the regulator. This pressure is controlled by the
regulator and is always less or equal to the air
CLOSED
OPEN
tank pressure.
rEGulAtor
The regulator knob (F) controls the air pressure coming from the air
tank.
to Adjust regulator:
1. Pull regulator knob (F) out.
I
. Turn knob clockwise to increase regulated pressure and
counterclockwise to decrease regulated pressure.
3. When desired pressure is shown on the regulated pressure
A
gauge push knob in to lock.
InStALLAtIon
Assembly (Fig. 1)
InstAllInG HosEs
WARNING: Risk of unsafe operation. Firmly grasp hose in hand
when installing or disconnecting to prevent hose whip.
1. Ensure regulated pressure gauge reads 0 PSI (0 kPa).
9
J
D
E
F