Trimmer / Brush Cutter Assembly; General Operation Advice; Adjusting The Trimmer Cord; Trimmer Parts - Trueshopping MT260 Manual Del Usuario

1. Unfold the hedge cutter
attachment by pressing the two
locking levers (1)
2. While still pressing the locking
levers rotate the adjusting lever
(2) to the desired angle, then fix
the locking lever to the gear ring.

Trimmer / brush cutter assembly

General operation advice

! Any hard objects e.g. Stones, metallic and
plastic objects should be removed from the
area before operation. Otherwise they can
be thrown up and cause damage to the
machine and Injury.
! Grass height in the working area should not
exceed 15cm due to the danger of hidden
Debris.
! Only for use on grass, weeds and low
shrubbery.
! When the unit is running, never put the
trimmer / brush cutter on the ground.
! Never cut above shoulder height and ensure
you have firm footing at all times.
! If you are unsure about any of the
procedures outlined, please contact the
manufacturer.

Adjusting the trimmer cord

!
The trimmer head will still run for a short
time after switching off the machine. Wait
until the machine comes to a complete stop.
When the trimmer cord becomes too short
after use, tap the spool head on solid ground
several times. This will unlock the spool head
and extend the cord through centrifugal force.
The line cutter will automatically trim it to the
correct length.

Trimmer parts

Brush cutter parts

12. Blade
13. Line cutting knife
14. Mounting screw and washer
15. Mounting washer
16. Blade protection
17. Locking nut
18. Spacer disc

Attaching the guard / line cutter

! Be careful when handling the line cutter, it
is sharp.
! The guard must be attached when using
either the trimmer or brush cutter
The following parts are required to fit the
guard and line cutter
4 x locking bolts
4 x locking nuts
4 x washers
1 x 4mm Allen key
1 x spanner
•
Loosen the metal mounting bracket using
the 4mm Allan key and spanner
11