Installation Of The Machine - ELMECO Quickream Manual De Uso Y Mantenimiento

During maintaining and
malfunctioning, disconnect the machine from the electric
network, by unplugging it - do not pull the wire but the
plug itself - (pict. 2 and 3).
Repairing must be made only by authorized and skilled
technicians. Reparations that are not state-of-the art may
be dangerous for the user. Please contact our company to
know the Authorized service centre closer to you.
This machine for the production of ice cream, temperature-based, grants the absolute homogeneity of the product and
the regulation of its density, through an innovative electronic control.
Before installing the machine, verify that:
 Quickream is located far from any heating source;
 The machine is not damaged during the transportation. In case of doubts consult your vendor;
 The power supply plant is endowed with a grounding system in accordance with applicable law;
 The electric capacity complies with the maximum power of the machine itself, as stated in the plate (picture 4
page 20).
If any doubt or concern please only contact trained and authorized personnel.
Carefully read the following instructions before installing the machine.
This machine must be used only for the purposes it was manufactured for. Any other use is to be considered as
dangerous.
It is recommended that the installation is carried out by a skilled technician. The manufacturer will not be held
responsible under any circumstances for a wrong installation that could cause damage to people or things.
Once unpacked, verify that the machine is intact. The packing elements (plastic bags, expanded polystyrene, nails, etc.)
must not be left at children's reach as they can be dangerous.
During transportation, do not lift Quickream by using the transparent tanks. Elmeco will not be held responsible
for the above mentioned wrong maneuvers
We recommend NOT to connect the machine through adaptors, multiple plugs and/or extensions.
If necessary, only use materials in accordance with the existing security laws concerning the power intensity as indicated
in the plate data (pic.4 page 20).
Place the machine far from any heating source. Verify it has sufficient free space (more or less 25 cm) around it.
Place the machine on a counter that can bear its load.
After connecting the machine to the electric network and switching it, verify the air flow from the side grids.
cleaning, or in case

Installation of the machine

of
Warnings
Installation
- 21 -