Keypad Lock - ELMECO Quickream Manual De Uso Y Mantenimiento

 When the product is ready, you can see "READY TO SERVE" on the display. In this case, the speed of the augers
decrease to 40rpm (default); this may be adjusted by changing the submenu settings in the SERVICE section;
It may happen that during production of ice cream, with a temperature of product below -2,0°C/28.4°F, the machine is
switched off, acting on main switch, or stop the rotation of the augers, acting on the augers switch
press of one of the two buttons, main switch or augers switch
When this procedure is activated, the augers will remain in stop position until the "9" becomes "1". After this time
(countdown counter) the augers will return to work and the electronic board will set in the previous condition before of
the shutdown. During the countdown must not be pressed any key.
To avoid reset of the above mentioned "WAIT 9 MINUTES FOR AUGERS" function, it is important that the
machine is not switched 'on' or 'off' when the countdown function is active.
This procedure serves to protect the gears and augers from abnormal loads caused by some ice pieces at the
bottom of the stainless steel. The ice can cause noise deriving from the gears that skid until the complete block
of the augers. If the machine does not restart, call the service support.
In the event the product in the tank is ready, i.e. on "Soft Mode READY TO SERVE", the display may show the following
warning:
This procedure is active when there is a lack of product in the tank. In this case, the solenoid valve will not be fed for a
period of 5 minutes, to avoid the formation of ice on the bottom of the tank; after this time limit the procedure is
deactivated.
If this occurs re-fill the tank.
During the "Soft Mode Wait Please" cooling stage of the product or during product maintenance, the "□" symbol may
appear on the upper left corner of the screen. Read the Quickream trouble shooting guide on p.33 for further
information.
SOFT MODE
WAIT PLEASE
The key pad can be locked, with the exception of the MENU key. To lock the keyboard proceed as follows:
1. To view the menu options, press the
2. Use the or
READY TO SERVE
WAIT 9 MINUTES
□
SOFT MODE
WAIT PLEASE
keys to scroll to the KEYBOARD screen.
> KEYBOARD
SOFT MODE
, you can see on the display
FOR AUGER
LOW MIX
PLEASE REFILL
SOFT MODE
READY TO SERVE
Key pad lock
key on the electronic control panel.
- 26 -
. With the next
□ SOFT MODE
READY TO SERVE