ELMECO Quickream Manual De Uso Y Mantenimiento página 25

- Remove the horizontal and vertical augers as shown in pic.10-11-12;
- Dip all parts in a solution of warm water and bleach (10 gr/litre of water) and rub with the cleaning brush provided;
- Wash with fresh water and dry all washed parts;
- Prepare some other solution of warm water and bleach (10 gr/litre of water) and dip a cloth in it. This will be used to
clean the steel tank and the parts connected to it (pic.13);
- Use a damp cloth to clean all the external parts;
We recommend lubricating the points indicated in fig. 14 (auger mechanism and front side of the horizontal
auger) with food-grade Vaseline, to avoid any eventual noise (whistle) due to friction between the two plastic
elements.
- Wet the gasket before inserting it in its place. Please be careful and insert the gasket with its junction in one of the
rear corner;
- Reassemble the machine.
On removing the piston from the container, carefully follow the steps in the images below to dismantle the shaft seal.
The tool in the images is provided with the Quickream machine.
After disassembly, wash the seal and the piston housing as described in the cleaning paragraph and reassemble the
parts.
Disassembling the piston seal for cleaning
1
4
7
2
5
- 23 -
3
6