Yakima LandingPad 11 Manual De Instalación página 4

ADjusT lANDiNG PAD PosiTioNs THEN TiGHTEN THEM DoWN.
• Place a towel on your roof to
protect your vehicle's finish.
• using your control tower
instruction as a reference,
carefully place a bar and
towers assembly onto the
landing pads.
• Adjust position of landing
pads to allow the control
towers to fully close.
noTe: Due to manufacturing variations the fastening hardware may bottom out in the hardpoint before the landing pad is fully tight.
if you encounter this situation, go back to step 6 and re-install with additional metal washer(s) (up to 3) to take up the slack.
READ THESE WARNINGS!
Be sure all hardware is secured according to instructions.
Make sure Control Towers,
with bars installed, seat
completely with Landing
Pad. If they do not seat
properly, repeat step 7.
Continue with Control Tower installation.
1033512D-4/24
Failure to perform safety checks before driving away can
result in property damage, personal injury, or death.
Attachment hardware can loosen over time. Check and
tighten if necessary, before each use.
To avoid damage your vehicle's finish remove and clean
Landing pads and mounting points periodically as road
sediment will accumulate over time.
• Remove the bar and towers VERY
CAREFULLY so that the landing
Pad position does not change.
• set the bar and towers assembly
on the towel as shown.
• Now fully tighten landing pad
with long handle as shown. Do
NoT ovER TiGHTEN As DAMAGE
To RooF oR MouNTiNG PoiNTs
MAy occuR.
• Repeat the process again for the
other landing Pad to ensure it
has not changed position.
Do NoT EXcEED MAXiMuM WEiGHT
liMiT FoR youR vEHiclE (sEE ATTAcHED
FiT cHART, yAKiMA FiT lisT, coNTAcT
youR DEAlER, oR coNTAcT yAKiMA).
To see Weight limits for your vehicle, or load limitations for
accessories, check the yakima Fit list, contact your yakima
dealer, or visit www.yakima.com, or call (888)925-4621
Remove your YAKIMA rack and accessories
before entering automatic car washes.
Monday through Friday,
7:00 AM to 5:00 PM, PsT