Electrical Connection - Candy PVC 220 Instrucciones De Empleo E Instalación

INSTALLATION - ELECTRICAL CONNECTION
"The installation must conform to the standard directives."
CANDY declines all responsibility for any damage that may be caused by unsuitable or
unreasonable use.
Warning :
• Always check before any electrical operation, the supply tension shown on the
electricity meter, the adjustment of the circuit-breaker, the continuity of the
connection to earth to the installation and that the fuse is suitable.
• The electrical connection to the installation should be made via a socket with a
plug with earth, or via an omnipole cut-out switch with an opening gap of at least
3 mm.
• The yellow/green wire of the power supply cable must be connected to the
earth of both power supply and appliance terminals.
• Candy cannot be held responsible for any accidents resulting from the use of an
appliance which is not connected to earth, or with a faulty earth connection
continuity.
• Any queries regarding the power supply cord should be referred to After Sales
Service or a qualified technician.
A power cord is not supplied with the appliance, but the hob is equipped with a terminal
block which enables you to choose the correct connection for the particular power supply.
The terminal block permits different connections :
. Monophase
. Monophase
. 2 phases + Neutral
. Three phase
. 3 phases + Neutral
20 -
220-240V2~
380-415V1N~
380-415 V2N~
220-240 V3~
380-415 V3N~