Installation - Sony XAV-W651BT Manual De Instrucciones

Using the wired remote control
When using the steering wheel remote
control
Installation of the connection cable RC-SR1 (not
supplied) is required before use.
1
To enable the steering wheel remote control, select
[General Settings]  [User Defined] to make the
registration (page 18).
When the registration is complete, the steering
wheel remote control becomes available.
Notes on installing the connection cable RC-SR1 (not
supplied)
• Refer to the support sites on the back cover for details,
then connect each lead properly to the appropriate leads.
Making an improper connection may damage the unit.
• Consulting the dealer or an experienced technician for
help is recommended.
When using the wired remote control
1
To enable the wired remote control, set [Steering
Control] in [General Settings] to [Preset] (page 18).
Using the rearview camera
Installation of the rearview camera (not supplied) is
required before use.
The image of a rearview camera connected to the
CAMERA IN terminal is displayed when:
– the back lamp of your car lights up (or the shift
lever is set to the R (reverse) position).
– you press HOME, then touch [Rear Camera].
– you press and hold DSPL then touch [Rear
Camera] if [SOURCE Key Func.] is set to [DSPL]
(page 19).
34
GB

Installation

Removing the bracket
Before installing the unit, remove the bracket 
from the unit.
1
Insert the release keys  into the catches
between the unit and the bracket  at the
same time until they click.


Catch
2
Pull down the bracket , then pull up the
unit to separate them.
Face the hook inwards.