Hole to Front
●
M
●
C
●
I
●
J
8
●
G
●
I
●
N
●
O
●
L
●
P
●
K
ENGLISH
HOW TO ASSEMBLE
Assemble completely and charge batteries for 14-16
hours before using.
●
H
CAUTION: Use only Eureka charger model 351-U-1025-1A
Have a screwdriver available for assembly (not included).
Attach Handle Grip
Step 1: Locate the 2-part bolt
Step 2: Align the handle grip and handle tube holes and
secure with the 2-part bolt
FIG. 1
Note: The single hole in the handle tube faces
Attach Handle
Step 1: Use your thumb to pull back on the lock button
Step 2: Push handle
Step 3: Release lock button
it locks into place.
Secure Wall Bracket on Wall
Have a 1/4 inch drill available for assembly (not included).
Cleaner hangs in bracket with the nozzle end down. Mount
on a wall in close proximity to an electrical outlet where
there are not dangerous objects hidden beneath the wall
surface like electrical wires, pipes, etc. Leave 14 inches
FIG. 2
above the floor for clearance.
Step 1: Hold bracket
screws. Make sure the wall bracket is positioned
vertically, with the charger socket at the bottom.
Step 2: Use a 1/4 inch drill for drilling holes for the plastic
anchors
Step 3: Insert the anchors
both holes.
Step 4: Tighten the screws
Step 5: Place cleaner, with the nozzle pointed down, on the
wall bracket
Step 6: Plug the charger
Note: This charger has been designed to use as either
FIG. 3
a wall mounted charger or to sit on a counter or
shelf
next to an electrical outlet. Take the battery
out of the cleaner and put in the counter bracket
●
I
. The charge light
the battery is charging (Fig. 4).
FIG. 4
(CONTINUED)
(Fig. 1)
●
H
in the assembly package.
forward in relation to the handle grip.
(Fig. 2)
●
G
into top of cleaner.
●
M
and rotate handle
●
I
against wall to mark location for
●
N
.
●
N
and drive the screws
●
O
to secure the bracket
●
I
.
●
L
into an electrical outlet.
●
P
. To use on a counter or shelf, locate
●
J
or
●
H
. Tighten the bolt.
●
M
.
●
G
until
(Fig. 3)
●
O
into
●
I
.
●
C
●
K
will indicate that