MASTER AUDIO DESIGN TSL DIGITAL Manual Del Usuario página 33

Once the data has been introduced for all programs, it is possible to go through
all of them by pressing repeatedly the
After the correct data has been introduced, it should be stored. To do this, the
key must be pressed during three seconds. At this time the TSL checks
the consistency of the weekly program and displays a message telling if the
weekly program is correct or it contains errors:
Program OK
Should errors be found, the TSL tells which is the first program containing one.
An error is detected when the TSL has been programmed inconsistently, that is,
the beginning time for a certain interval is earlier than the beginning time of the
previous interval, producing this an overlap. For instance, a cause for the Error
in Prg2 could be the following:
Prg2 Mode:MUTE
Begin :Tue 03:00
The BYPASS interval begins before the MUTE interval, and this causes the
error. When an error is detected, the TSL goes to the program which caused it
so that the user can check and modify it. The TSL only tells which program is
wrong, but not which interval. This should be checked by the user.
Once the weekly program has been introduced without errors, the TSL is ready
to follow it. It will start the program when the user leaves the main menu (option
Exit CONFIG) and goes back to the main screen.
Bypass Dates: Regardless the weekly program, it is possible to program 10
events in which the TSL is set to the BYPASS mode. This section explains how
to program these events, called "Bypass Dates".
The Bypass Dates have three parameters to be programmed:
a) Whether the event repeats every year or takes place only once
b) Beginning date of the event
c) End date of the event
When entering this menu, the first thing to do is select one of the available
memory slots, from 0 to 9:
key.
Error in Prg2
Prg2
Begin: Tue 02:00
Bypass Dates
Bypass Date 0
32