Dutch originals DO-SV-BTB5-B Manual Del Usario página 13

Power connection
Before connecting the AC power cord, make sure you have completed all other
connections.
• Prior to use, check that the mains voltage is the same as the mains voltage stated
on the device.
• Plug the power plug into the mains supply.
• Plug the power plug of the power cord into the AC power socket of the device
• The device is now in standby mode. The standby LED indicator
Power ON/OFF – Standby
Press the power button on the device
device's remote control to switch it ON.
The LED indicator
Press the power button on the device
device's remote control to switch the device to standby mode. The LED Indicator
will light up red.
Disconnect the power plug from the mains supply if you want to switch the device
OFF completely.
Please note:
If the device is not in use (no input), it will automatically go into standby mode
after 15 minutes.
If the device's external input signal is too low, it will automatically go to standby
mode after 15 minutes. Please increase the input signal of your externally connected
device.
of the last used source mode will light up.
6
or press the power button
5
or press the power button
5
12
will light up red.
6
on the
A
on the
A
6
EN 11
.