EAS ELECTRIC ETW7020DW Manual De Usuario página 43

Clean the inlet valve filter
The inlet filter shall be cleaned if there is not any or insufficient water in when
the tap is opened.
1.Lower the water pressure:
a. Close the tap.
b. Select any procedure except "Spin"
procedure.
c. Press the button "Start/Pause" and
keep the procedure running for about 40
seconds.
d.Pull out the power plug.
2.Remove the inlet hose from the tap.
3.Use water to wash the filter.
4.Reconnect the inlet hose.
Clean detergent drawer
1.Press down the part① inside the drawer
and take out the detergent drawer.
2.Lift the clip up and take out
cover and wash all
3.Restore the softener cover and
Dispose an easily get frozen washer
If the washer is exposed to temperature below 0°C, certain precaution should be
taken.
1.Turn off the tap.
2.Unscrew the inlet hose.
3.Unhook the drain hose from the rear support and position the end of
hose and that of the inlet hose in a bowl. Run the spin programme.
4.Disconnect the washer.
5. Screw the inlet hose and reposition the drain hose.
NOTE:
1.When the washing machine is reused, make sure the ambient temperature is
above 0°C.
2.If your washing machine is located in the room where it can get frozen easily,
please drain the remaining water inside drain hose and inlet hose thoroughly.
3.Please contact a technician if your washer is frozen.
softener
grooves with water.
push the drawer into positon.
43 43
this
V.2 V.