Installing The Light Kit - Hinkley 60" GLADIATOR ILLUMINATED Manual De Instrucciones

INSTALLING THE LIGHT KIT

Adapter Plate
Fig. 1
1
Remove the 1 of 3 screws from the mounting hub and keep it
for future use. Loosen the other 2 screws. (Do not remove)
Place the key holes on the adapter plate over the 2 screws
2
previously loosened from the mounting hub , turn adapter plate
until it locks in place at the narrow section of the key holes.
Secure by tightening the 2 screws previously loosened and the
one previously removed. (Figure 1)
Mounting Hub
(bottom of motor)
Screws
Wire Connectors
Light Kit Assembly
Fig. 2
Remove 3 screws from the adapter plate.
1
Raise and hold the Detachable Switch housing close to the
2
adapter plate and push the square wire connectors together.
(Fig. 2)
Install the light kit assembly to the adapter plate with three
3
screws previously removed.
Screws
©2019 Hinkley Lighting, Inc. | hinkley.com | 11