Installation The Switch Housing And Light Kit - Hinkley 52 PROPEL ILLUMINATED Manual De Instrucciones

INSTALLATION THE SWITCH HOUSING AND LIGHT KIT

NOTE: Be sure the power is off before installing.
Remove and discard the plug from the switch housing,
1
attach the light kit to the switch housing by feeding the
light kit wires (black and white) through the hole of switch
housing and then screw it onto the switch housing by nut
& lock washer. Be sure it is tight enough to prevent light
kit from vibrating loose. (Fig. 1)
While holding the light kit assembly under your fan, snap
2
together the wire connection plugs. (Fig. 2)
Carefully push all wires back into the switch housing, then
3
install the light kit assembly onto the adapter plate with 3
screws provided. Be sure to tighten all screws.
4 Install 9 Watt LED Bulbs (included). (Fig. 2)
Remove the decorative nut, glass cap, nut and rubber
5
washer from the light kit . Place glass shade over the light
kit stem, secure with the rubber washer, nut, glass cap and
decorative nut. Do not overtighten. Insert the fan pull chain
through the eyelet in the light kit, shade and glass cap.
Also insert the light kit pull chain through the shade and
nut. (Fig. 2)
Turn the power on. Your Regency Ceiling Fan is now ready
6
to enjoy!
Nut
Lock Washer
Plug
12 | hinkle y.com
Bulbs
Switch Housing
Light Kit
Fig. 1
Wire Connection
Plugs
Light Kit
Assembly
Rubber Washer
Nut
Glass Cap
Decorative Nut
Adapter Plate
Screws
Glass shade
Fig. 2