Tabla de contenido
Publicidad
Idiomas disponibles
Idiomas disponibles
Switch on the mains voltage to all EPL modules.
• The Conf. LED flashes on all modules. This means that the EPL modules are not
configured/programmed (default setting) (fig. 1).
• If the Conf. LED does not light, you must reset the device.
• Press and hold the Reset button for around 6 s. The Conf. LED will then flicker briefly.
A few seconds after releasing the Reset button, the Conf. LED will flash regularly,
indicating that the EPL module has been reset to the default setting.
• Use a screwdriver to briefly press the Prog. button on any EPL module.
• The EPL module will then automatically create a domain with a certain coding.
All unconfigured EPL modules in range will program themselves automatically to
GB
this domain.
This ensures that EPL modules of different domains cannot interfere with each other.
• The modules are programmed and ready for operation after 5 s - 10 s.
All Conf. LEDs stop flashing.
• If one EPL module's Conf. LED continues to flash, follow the practical advice under Point 5.
• To extend an existing domain, follow the procedure outlined under Point 4.2.
• Display and operating system (fig. 1)
• Function of the Func. switch (fig. 1)
Adresse
EPL-Transmitter/1
A
0 2
Conf. Reset
O
C
14
M
E
12
EPL-Transmitter/3
K I G
10
8
g
e
EPL-Receiver/M
EPL-Transceiver/TLA
EPL-Transceiver/M
(1) Connection of a button: ON or OFF whenever pressed. (2) Connection of a switch
with defined ON/OFF setting. (3) Connection of a change-over switch: ON or OFF
whenever pressed (4) Connection of a button: UP/BRIGHTER input 1, DOWN/DARKER
input 2, optional STOP input 3. (5) Connection of a button and a wind sensor: UP/
BRIGHTER input 1, DOWN/DARKER input 2, wind sensor at input 3 moves all
drives UP and blocks them in the position until the contact at input 3 is re-opened.
(6) Drive moves to end position (max. 120 s) at a quick button press. (7) Drive moves for
as long as the button is pressed. (8) Drive moves to end position (max. 120 s) at a long
button press. If the button is pressed briefly the slats are adjusted. (9) Connection of a
button: ON for the duration of the time setting whenever pressed. (10) Connection of a
change-over switch: ON for the duration of the time setting or OFF.
16
Conf.
Reset
Adresse
Button (1)
A
0 2
Conf. Reset
Conf. Reset
O
C
14
4
M
E
12
4
6
Button (4)
K I G
10
6
8
g
e
Convenience function (6)
Button (9)
Convenience function (6)
Adresse
A
0 2
Conf. Reset
O
C
14
M
E
12
4
K I G
10
6
8
g
e
g
Adresse
ON/OFF switch (2)
A
0 2
O
C
14
M
E
12
4
K I G
10
6
Shutter controls
8
g
e
Standard function (7)
Standard function (7)
Func.
Prog.
e
Change-over switch (3)
Button & wind sensor (5)
Inching & convenience
function (8)
–
Change-over switch (10)
Inching & convenience
function (8)
Publicidad
Tabla de contenido
