Typical Installation - Broan LOSONE SELECT L900L Manual De Instrucciones

TYPICAL INSTALLATION

MOUNTING (New Frame Construction)
12" ROUND DUCT
(OUTLET)
GRILLE NUT
(Install into square
holes in housing)
Ventilator
factory-shipped
in straight-through
discharge position.
ACCESS
PANEL
SCREW
Factory-shipped unit installed in new construction.
MOUNTING (Existing Frame Construction)
8" X 12" TO 12" ROUND
TRANSITIONS
12" ROUND
DUCT
(OUTLET)
FINISHED
CEILING
MATERIAL
CEILING
JOIST
(24"
centers
shown)
Ventilator factory-shipped
in straight-through
discharge position.
PANEL SCREW
Factory-shipped unit installed in existing construction.
8" X 12" TO
12" ROUND
TRANSITIONS
12" ROUND
DUCT
(INTAKE)
MOUNTING
BRACKETS
CEILING
JOIST
(24" centers
shown)
ACCESS PANEL
12" ROUND
DUCT (INTAKE)
MOUNTING
BRACKETS
MOUNTING
SCREWS
GRILLE NUT
(Install into
square holes in
housing)
ACCESS
ACCESS
PANEL
TYPICAL INSTALLATION
WIRING
BLACK
TO
BLACK
WHITE
TO
WHITE
Ventilator can be wired from outside of housing.
Use UL approved connectors to wire per local codes.
DUCTING (Straight-through blower discharge)
12"
ROUND
8" X 12"
DUCT
TO
12" ROUND
TRANSITIONS
Two ways to connect ductwork to a factory-shipped unit.
IMPORTANT:
Remove shipping tape from damper
Remove the shipping tape from the damper flap and make sure
that damper flap opens and closes freely inside the ductwork. Use
duct tape to make ductwork connections secure and air-tight.
MODELS • L900L • L1500L
EDGE
OF HOUSING
GROUND TO
WIRING PLATE
WIRING
PLATE
120 VAC LINE IN
ROOF CAP
12"
ROUND
DUCT
12" ROUND
ELBOW
Page 2
WALL
CAP