How to Install the Alkaline Batteries
1. Remove the battery cover by releasing the latch and sliding the cover down and
off the handle. You may need a screwdriver or similar tool to do this.
2. Install two "D" size alkaline batteries as shown in
3. Reinstall the battery cover by aligning it with the handle and sliding it up until
the latch engages.
NOTES:
Low battery is indicated by the green POWER indicator flashing. TEK-Mate
may continue to operate for up to one hour.
Dead battery is indicated by the POWER and HIGH indicators flashing.
Figure 1. Properly Installed Alkaline Batteries
- +
+
NOTE: Dispose of depleted alkaline batteries according to applicable state and
local regulations. In the absence of such regulations, recycle and/or
dispose of batteries through voluntary waste recycling programs.
-
5
Figure 1.