Personalisations; Setting The Temperature; Setting The Spin Speed; Options - Indesit WIXXL 86 Manual De Instrucciones

Ocultar thumbs Ver también para WIXXL 86:
Tabla de contenido

Publicidad

Idiomas disponibles

Idiomas disponibles

Personalisations

Setting the temperature

Turn the TEMPERATURE knob to set the wash temperature (see Programme table on page 6).
The temperature can be lowered, or even set to cold wash ( ).

Setting the spin speed

Turn the SPIN SPEED knob to set the spin speed for the programme selected.
The maximum spin speeds for each programme are as follows:
Programmes
Maximum spin speed
Cotton
800 r.p.m.
Synthetics
800 r.p.m.
Wool
600 r.p.m.
Silk
no
The spin speed can be lowered, or the spin cycle can be excluded altogether by selecting the symbol
The washing machine will automatically prevent you from selecting a spin speed higher than the maximum speed
for each programme.

Options

To enable an option:
1. press the button corresponding to the desired option, according to the table below.
2. the option is enabled when the corresponding button is illuminated.
Note: The rapid flashing of the button indicates that the corresponding option cannot be selected for the
programme set.
Option
Effect
Delays the start of the
wash by up to 9
hours.
Delay Timer
For washing a smaller
load.
Mini Load
This option reduces
the amount of
creasing on fabrics,
making them easier
to iron.
Easy Iron
Increases the
efficiency of the rinse.
Extra Rinse
Tr9231gb_WIXXL86-Indesit.p65
Comments
Press the button repeatedly until the LED corresponding
to the delay is turned off.
The fifth time the button is pressed, the option will be
disabled.
N.B. Once you have pressed the Start/Reset button, the
delay can only be decreased if you wish to modify it.
In addition to reducing actual washing time, this option will
reduce water and energy consumption by up to 50%.
Note: You can reduce the amount of detergent you use
with this wash.
When this option is set, programmes 4, 5, 6 and 7 will end
with the laundry left to soak (Anti-crease) and the Rinse
cycle phase LED
- to conclude the cycle, press the START/RESET button.
- to run the draining cycle alone, set the knob to the
relative symbol
Recommended when the appliance has a full load or with
large quantities of detergent.
7
will flash.
and press the START/RESET button.
20/01/05, 14.39
GB
.
Enabled with
programmes
All
1, 2, 3, 4, 5
Rinse cycle
3, 4, 5, 6, 7,
8, 9, 10,
Rinse cycle
1, 2, 3, 4, 5,
8, 9, 10, 12, 13
Rinse cycle
7

Publicidad

Tabla de contenido
loading

Tabla de contenido