Transferring Measurements - Beurer BM 85 Manual De Instrucciones

8. Transferring measurements

Transfers using the USB interface
Connect the blood pressure monitor to your PC using the USB
cable.
No data transfer may be launched whilst performing a
measurement.
PC is shown on the display.
Begin the data transfer in the "beurer
HealthManager" PC software. During the data
transfer, an animation is shown on the display.
A successful data transfer is displayed as in
figure 1. If the data transfer is unsuccessful, an
error message appears as in figure 2. In this case,
interrupt the PC connection and start the data
transfer again.
After 30 seconds of not being in use or if commu-
nication with the PC is interrupted, the blood pres-
sure monitor switches itself off automatically.
Bluetooth low energy technology transfers
®
It is also possible to transfer the measured values saved on
the device to your smartphone using Bluetooth
technology.
You will need the "beurer HealthManager"-app for this. This is
available in the Apple App Store and from Google Play.
Proceed as follows to transfer values:
data is transferred if Bluetooth
tings menu. The symbol appears in the top left of the display
(see section 4 "Preparing for the measurement").
fig. 1
fig. 2
® low energy
has been activated in the set-
®
Step 1: BM 85
activate Bluetooth
4 "Preparing for the measurement, Blue­
tooth ").
®
Step 2: „beurer HealthManager" app
In the „beurer HealthManager"-app, add the
BM 85 under "Settings/My devices".
Step 3: BM 85
take a measurement.
Step 4: BM 85
data transfer immediately
following measurements.
• Select the desired user
memory. Start Bluetooth
data transfer (chapter 5)
The "beurer HealthManager"-app must be active to allow
data transfers.
34
on your device (see section
®
Step 4: BM 85
Data transfer at a later point:
• go to memory mode
(chapter 7). Select the
® desired user memory.
Bluetooth data transfer
®
starts automatically.