Charcoal Filter
The charcoal filter cannot be cleaned. It
must be replaced. Order Part No. JX81A
from your GE supplier.
If the model is not vented to the outside,
the air will be recirculated through
a disposable charcoal filter that helps
remove smoke and odors.
To Remove the Charcoal Filter
To remove the charcoal filter, first disconnect
power at the main fuse or circuit breaker,
or pull the plug. Remove the top grille
by removing the two screws that hold it
in place.
Remove 2 grille screws
You may need to open the cabinet doors
to remove the grille.
to remove the screws.
You may want to open the microwave
door before removing the grille.
To Install the Charcoal Filter
To install a new charcoal filter, remove
plastic and other outer wrapping from
the new filter.
Insert the top of the filter up and into the
grooves on the inside of the top opening.
Push the bottom of the filter in until it rests
in place behind the tabs.
The charcoal filter should be replaced when
it is noticeably dirty or discolored (usually
after 6 to 12 months, depending on usage).
See "Optional Kits," page 7, for more
information.
Lift the filter at the bottom until it comes free
of the tabs. Slide the filter down and out.
g g e e . . c c o o m m
29